Leaderboard
Popular Content
Showing content with the highest reputation on 02/20/2019 in all areas
-
1 point
Metal Prep After Media Blasting
RPM reacted to Ridge Runner for a post in a topic
I have never charged more than $900 to blast a car inside and out ...i have to up my rates haha -
1 pointI bought these from Coker tire a few months back, they are Specialty Wheels. Looks like they are around 14.5"
-
1 pointListen closely and you'll hear them rust!
-
1 point
Metal Prep After Media Blasting
RPM reacted to Ridge Runner for a post in a topic
I always DA or hand sand even after sand blasting before epoxy . Get it in primer as soon as possible ,especial if it is cold or raining . Rust will start fast -
1 pointI'll get you those measurements in a bit.
-
1 point
Car Mounted on Rotisserie. Questions?
RPM reacted to Ridge Runner for a post in a topic
Oh you will regret selling it . I sold my first one i made thinking i would not need it again ...i have 3 now and they are always in use . I have done everything from frames for my 35 - 37 fords to an 80s Cadilac ,and a couple of Impalas . You can addapt them for almost anything -
1 point
New welder
RPM reacted to Mach1 Driver for a post in a topic
I probably don't need TIG. I have some panel gaping to do and a repair on one door that needs cutting out and replaced. Then I was thinking of inner rockers and subframe connectors. There are some things I want to make for the house, but TIG probably isn't a necessity...I just want it.