Gray69 5 Report post Posted January 9, 2022 Does anyone know of a source for the upper pivot rods and the lower pivot rod sleeves? I actually have the upper pivot rods but do not have the thin metal piece that it is screwed to. Found Scott Drake includes them in a complete assembly but I have the other components so don't need the entire assembly. Also looking for the lower sleeves/bushings if someone has a source for something that can be used in place of those. Thanks in advance. Matt Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted January 9, 2022 I made two out of milk carton plastic. I used a heat gun to form the plastic around shaft. Quote Share this post Link to post Share on other sites
aslanefe 333 Report post Posted January 9, 2022 36 minutes ago, RPM said: I made two out of milk carton plastic. I used a heat gun to form the plastic around shaft. Did you use 2% or whole milk jug? :) Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted January 9, 2022 Full power only in my house. 2 percent has too much sugar added. Although I'll eat a half gallon of ice cream in one sitting. 1 Mach1 Driver reacted to this Quote Share this post Link to post Share on other sites
Caseyrhe 650 Report post Posted January 9, 2022 I used a Whataburger straw on the lower 1 TexasEd reacted to this Quote Share this post Link to post Share on other sites
Midlife 814 Report post Posted January 9, 2022 14 hours ago, RPM said: Full power only in my house. 2 percent has too much sugar added. Although I'll eat a half gallon of ice cream in one sitting. Wimp! I'll tackle a full gallon at one sitting. Quote Share this post Link to post Share on other sites
Mach1 Driver 560 Report post Posted January 9, 2022 Ice cream headache! Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted January 10, 2022 3 hours ago, Mach1 Driver said: Ice cream headache! But it hurts so good. 1 Midlife reacted to this Quote Share this post Link to post Share on other sites
Gray69 5 Report post Posted January 11, 2022 Not in Texas, so no Whataburger here in Central AR though they have them in NWA now. For the lower plastic bushing, found that the pump tube in my wife's shampoo bottle fits perfectly and is slighter thicker than the original. Going to be funny to watch her confusion when a half full bottle stops delivering shampoo. :) For the upper rod, I will make a spacer for it. 2 3 Caseyrhe, RPM, jjstang and 2 others reacted to this Quote Share this post Link to post Share on other sites