Vicfreg 773 Report post Posted December 18, 2023 I have a new drivers front floor section, I’m trying to figure out where the proper location of the foot mounted highbeam switch is. A rough measurement would be fine, I don’t think it’s that critical Quote Share this post Link to post Share on other sites
Vicfreg 773 Report post Posted December 18, 2023 It’s just hanging there right now 1 Bryant reacted to this Quote Share this post Link to post Share on other sites
Brian Conway 264 Report post Posted December 18, 2023 Picture of mine. 1 shelbyshelby reacted to this Quote Share this post Link to post Share on other sites
Vicfreg 773 Report post Posted December 18, 2023 Brian, thanks! Quote Share this post Link to post Share on other sites
det0326 179 Report post Posted December 19, 2023 Don't know if you have your carpet in or not. I seem to remember some carpet manufactories pre cut the hole for dimmer switch and some don't. Quote Share this post Link to post Share on other sites
Vicfreg 773 Report post Posted December 20, 2023 Ahhhh...Good point. I do not have my carpet yet.... Quote Share this post Link to post Share on other sites
Mach1 Driver 560 Report post Posted December 20, 2023 Don't forget the plastic insulator under the switch, per Brian's photo. The connector often gets mashed down and shorts to the floor without it. Quote Share this post Link to post Share on other sites
Mike65 476 Report post Posted December 20, 2023 Mach 1 Driver I am in the same spot as Vic & will be installing mine soon also. Can you buy the insulator, or do I have to make one? Quote Share this post Link to post Share on other sites
Vicfreg 773 Report post Posted December 20, 2023 Yeah, I don’t have one either. I guess I could make one out of some insulating material. I have a couple old radiator hoses, I could cut a section out of that flatten it and screw it down. That’s probably what I’m gonna do. Quote Share this post Link to post Share on other sites
Mach1 Driver 560 Report post Posted December 20, 2023 The manual calls it a dimmer switch retainer. There were no hits on NPD. You should try WCCC too. Here is one on Ebay: https://www.ebay.com/itm/305027497117 Quote Share this post Link to post Share on other sites
Vicfreg 773 Report post Posted December 20, 2023 Thanks.! Quote Share this post Link to post Share on other sites
Mike65 476 Report post Posted December 20, 2023 Thanks. Quote Share this post Link to post Share on other sites
