RPM

This one?

If your diagram is the one I've attached, it is only the lower measurements. You will also need one which shows the upper measurements, those on the top of the radiator support, the fender aprons and cowl. A good body shop or frame shop should have the upper diagram.

Hey Ash, where in Oz are you?

Great idea and read Jason.

My pleasure jw. Silver_69_Coupe may have a pair of hubs.

Per Mustang Steve site... 67-73 Mustang 67-69 spindle or 70-73 spindle 67 V8 disc or drum, 68-69 drum only, 70-73 drum only Hubs 65-69 Mustang fit the 67-69 spindle, 70-73 Mustang hubs fit 70-73 spindle using 70-73 bearing 68-73 disc spindles and hubs DO NOT FIT

Depends on your particular springs.

Hood? The tandem caught my eye first!

Weiand has a way to check a manifold height. http://www.holley.com/data/TechService/Technical/Choosing%20A%20Manifold.pdf I used it when I got my Stealth.

Thanks BuckeyeDemon

I'm looking for both front drum spindles and hubs. Are yours drum and available?

Good job 1969coupe. Thanks Bruce :(

What does "get the wheels balanced by the lugs" mean?

Very nice work!

Just found this thread. Nice work for a 1st build.

Oh, just one more thing...Go Pack Go!

Thanks Angel. I already made my fixture to weld the arm and it's at 15 1/2". Numbers are next week for me, was working on colors this week.

Nobody...?

http://dazed.home.bresnan.net/drop and http://www.mustangmonthly.com/howto/mump_0705_upper_control_arms/viewall.html

Is this for an existing hole, or did you cut the hole then try to fit an antenna?

I'm not going to bend the arm, I'll weld the tube to the ball joint cup at an angle like the AFCO and Ron Morris arms are made. But if I was going to bend them I would have The Chassis Shop make the bends when I bought the tubing from them.

I went to measure mine and when I couldn't locate it, realized I had tossed it since it was pitted and needed replaced.

Hey guys, does anyone have easy access to the centerline measurement from the attachment point on the body to the center of the ball joint? I'm building tube arms and traded mine. I wrote down 14 1/2", but my jig is a different measurement and would like to confirm. Thanks, Bob.

Nice look! Do you know the diameter of the tires? Have you run it withe the new wheels yet? What size are the fronts? Any suspension mods to the front? Me likes!

I would contact the seller and advise him of the wrong title. It could be a simple mistake or a crime. If you receive the wrong, or no answers from him, contact the police. As they say in Vegas, good luck.