Raven R code 281 Report post Posted August 29, 2017 Feeling defeated right now! I cannot get the firewall grommets thru the hole without popping the top off the grommet. I've used rubber grease and all sorts of utensils and it still. Won't work. Help! Quote Share this post Link to post Share on other sites
MAC390 327 Report post Posted August 29, 2017 Are they for the heater hoses as i bought the grommets for the firewall and they don't fit . They are 70 models and mine just go through and have sealer around them where the come out of the firewall. Hope this help full. Quote Share this post Link to post Share on other sites
MAC390 327 Report post Posted August 29, 2017 Sorry , i thought you were doing heater hoses, didn't read the post correctly. Quote Share this post Link to post Share on other sites
larryc94 38 Report post Posted August 29, 2017 It takes two people, take an old screw driver and grind the end round, WD40 or similar lube (even soap). While you insert have other person try to grab with pliers the outside to pull through. I actually installed 2 pads (don't ask) one from cj's and one from NPD. Although the pads where similar the npd fasen might have been better or I became experience with those pins the second time. I think I may have used some of the original which where best Quote Share this post Link to post Share on other sites
Raven R code 281 Report post Posted August 31, 2017 Maybe they grommets are cheaper....but at least I got one on today. Try the other tomorrow. I ended up removing at little of the jute that surrounds the holes. Quote Share this post Link to post Share on other sites
Caseyrhe 650 Report post Posted August 31, 2017 I used 3m adhesive spray to hold it up, then came back and installed the inserts. Silicone as a lube Quote Share this post Link to post Share on other sites
Raven R code 281 Report post Posted September 3, 2017 After almost 2weeks , I have one Grommet installed (undamaged) . Lol. it looks like the small section under the steering column is attached wth 2 screws(and maybe a big washer?) Quote Share this post Link to post Share on other sites
larryc94 38 Report post Posted September 4, 2017 To the left of the column uses 2 screws with large flat washers Quote Share this post Link to post Share on other sites
69ShelbyGT350H 61 Report post Posted September 4, 2017 Quote Share this post Link to post Share on other sites
Raven R code 281 Report post Posted September 4, 2017 Awesome!, thanks for the input. Quote Share this post Link to post Share on other sites
shelbyshelby 52 Report post Posted September 4, 2017 Raven, here's the way I conquered those clips. I used s small string from the inside of a piece of paracord. Tie it to the tit end of the grommet and it'll pull thru without breaking the grommet. Quote Share this post Link to post Share on other sites
Raven R code 281 Report post Posted September 7, 2017 That sound like a plan! Quote Share this post Link to post Share on other sites