jerrywmalcolm 21 Report post Posted October 26, 2017 hi all, i have a 69 mach 1, i'm getting old and can't bend like i use to, i need to change the egn switch, how hard of a job is it?, i bought the switch from national parts, and i cana't even get the key cylinder to go into the main housing, probly end up letting someone else do it when i finally give up, any info out there?, thanks jerry Quote Share this post Link to post Share on other sites
69ShelbyGT350H 61 Report post Posted October 27, 2017 If you were anywhere near me I'd help you out. Should be easy. Are you replacing the cylinder or the entire switch? You mentioned you bought the switch so I'll guess its that. Quote Share this post Link to post Share on other sites
jerrywmalcolm 21 Report post Posted October 27, 2017 the whole switch Quote Share this post Link to post Share on other sites
unilec 57 Report post Posted October 27, 2017 I have never done a 69, but I know they have a tool to remove. https://www.cjponyparts.com/mustang-scott-drake-ignition-switch-assembly-1968-1969-installation-instructions/a/410/ Quote Share this post Link to post Share on other sites
jerrywmalcolm 21 Report post Posted October 27, 2017 thanks unilec, its going to be a big help Quote Share this post Link to post Share on other sites
jerrywmalcolm 21 Report post Posted October 27, 2017 UPDATE, wasn't the egn switch, turns out its the safety netural switch,on trans 1 RPM reacted to this Quote Share this post Link to post Share on other sites