Raven R code 281 Report post Posted March 3, 2014 Hi, Does anyone know if there are different size spotwelds on the 69? Specifically are all body panels the same size weld? I'm going to hang a rear quarter and possibly floorpan and I'm looking for the size cutter to buy. Also, is Rotabraoch the best cutter to go with? It seems like it to me, but then again I've never done this part before. Thanks, D. Quote Share this post Link to post Share on other sites
miketyler 15 Report post Posted March 3, 2014 Rotabroach is good. Also you can buy the double sided cutters to use with it or the BlairCutter system. Quote Share this post Link to post Share on other sites
jmlay 80 Report post Posted March 3, 2014 3/8 will get most everything. I have used all other types but I like the Blair 11094 best of all of them, especially of you are cutting heavy metal such as the frail rails. Make sure you get a deep center punch or drill a small starter so the cutter does not try to drift, drift WILL break teeth: Quote Share this post Link to post Share on other sites
miketyler 15 Report post Posted March 3, 2014 Here are the replacement cutters I was talking about. They are available separately http://www.ebay.com/itm/Blair-13214-3-pk-Double-End-Spotweld-Replacement-Cutters-BLR13214-3-8-/230988288924?pt=LH_DefaultDomain_0&hash=item35c7f9939c&vxp=mtr Quote Share this post Link to post Share on other sites
bomccorkle 12 Report post Posted March 3, 2014 I use both styles depending on where I'm working. I bought a skip proof in the 3 pc 3/8, and the small set in the standard pilot. I've found about a million uses for them. Quote Share this post Link to post Share on other sites
DocWok 30 Report post Posted March 3, 2014 Save your money and just grind up some old twist drill bits in what ever size you want. Grind the end of the drill bit flat and then grind a little bit of back rake on each side and leave a little dimple protruding in the middle. I've use them and they work great. Quote Share this post Link to post Share on other sites
Rsanter 152 Report post Posted March 3, 2014 I don't like using the spot weld cutters anymore There is always the chance you are going gut into the metal you want to keep, spot welds of different sizes, and deformed spot welds. I use a 3/8 round carbide bur on a die grinder. I grind off the top of the spot weld moving the ball around a bit. I also use the edge of a 4.5" grinder on the spot welds. When the metal gets thin there is a blue ring that shows up in the metal around the spot weld. Then it's thin enough to break the metal free. Grind the base material flat and you are ready to go Bob Quote Share this post Link to post Share on other sites
jmlay 80 Report post Posted March 3, 2014 The blair as well as the harbor freight have an adjustable stop so you can not drill to far. Frankly I find it a pain & have done enough I can do it by eye/feel. Quote Share this post Link to post Share on other sites
manley 13 Report post Posted March 3, 2014 I do what DocWok suggested. It helps that I have friends who work in a machine shop. We have the tool room guy grind the tips almost flat... and when they get dull, we send them back to have him sharpen them. Quote Share this post Link to post Share on other sites