Jump to content
Sign in to follow this  
rchappelear

what is this wiring part for

Recommended Posts

I think the shifter light travels through the trans tunnel and goes through a grommet into the shifter.

 

I'm thinking it is the heater light and lower ash tray lights. By adding the ash tray, the factory had to piggy back with the heater light so it could plug into the 3-way harness light feed. I know on my mach all three pins are filled, so the addition of the ash tray wouldn't work in my case without that piggyback shown in his pic. They two items (heater control and ash tray) are also very close to each other, thus the relatively short wiring length.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...