Raven R code 281 Report post Posted April 3, 2017 I need to locate a pin extractor for that green junction block. Any ideas where to get one or what size extractor tool is needed? Quote Share this post Link to post Share on other sites
Midlife 814 Report post Posted April 4, 2017 For male pins, a Bic pen shell works good, according to the Ford Shop Manual. Personally, I have used a jeweler's screwdriver, ground down on one side to half of its thickness. I use it on the female pins between the pin and the housing to bend the locking tab back, and on the male pins. The locking tab is 180* from the vertical slot where the pin sides come together in a joint. 2 JayEstes and mwye0627 reacted to this Quote Share this post Link to post Share on other sites