Floor support crossmember transmission

[jjstang 51]

Not exactly sure what the part is called but I guess you get the idea. 

 

I want to install the trans support for alignment purposes (replacing both floor supports)  When I went to bolt it in, there is two places on the drivers side of the cross-member.  Which one was used with the fmx.  One fits pretty easy , the other seems far off.  Just want to be sure I'm suing the correct one.  did I make sense?

[MikeStang 247]

Yep made sense to me... I am pretty sure it will only go into one hole actually...When I bolted my 4R70W up it would only hit one spot because the 4Ris larger than a C6, and I believe its the 1st hole... I could be wrong tho but that sounds right to me.

regardless it should sit relatively level   

[RPM 1,190]

I'm not sure which one is the first one Mike :) The driver's side mounts to the top hole for the FMX.

 

[jjstang 51]

Top hole, great! That's the one that fits best, thanks