Raven R code 281 Report post Posted November 19, 2016 From what I've seen in the catalogs, the door wire harness does not come with the stapled plastic square tube. Is there a safe way to open the tube to add the new harness? Quote Share this post Link to post Share on other sites
Ridge Runner 1,113 Report post Posted November 21, 2016 You have been Spamed HAHA. I just pulled the original wires out of my doors, the plastic case is stapled together .You should be able to cut the staples and pull them out .My wires are good enough to use again . Quote Share this post Link to post Share on other sites
Raven R code 281 Report post Posted November 21, 2016 i guess ,after closer examination, there are staples in there. I guess I will cut the staples out to put new harnesses in....and then glue the two halves together....unless the staples are standard size. Quote Share this post Link to post Share on other sites
RobotMan 264 Report post Posted November 21, 2016 They are standard size. I used staples from my staple gun. I took a small drill bit and cleaned existing holes out. I pushed new staples in and bent them over. Worked great. 1 Raven R code reacted to this Quote Share this post Link to post Share on other sites