Raven R code 281 Report post Posted September 16, 2016 Does anyone know where to get the sheet metal nuts that are used to secure the shaker trim ring to the hood? Thanks 1 BengerdCog reacted to this Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted September 16, 2016 If I was a gambling man I'd wager on McMaster Carr having them. Keep in mind there is a specific I.D. and O.D. it you're going concourse. I just picked up some locally with the correct ID for fit and not worrying that the OD was a bit small. Quote Share this post Link to post Share on other sites
Unkleen 11 Report post Posted September 16, 2016 AMK F-2156 Put that in google, you will find a couple vendors with them. CJPony for example. 1 Raven R code reacted to this Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted September 16, 2016 Thanks Unkleen. Quote Share this post Link to post Share on other sites
Raven R code 281 Report post Posted September 16, 2016 Good find! But I wonder if they are 10 cents a piece if you say they are for a Yugo. Anyone know if the nuts are body color or natural? Quote Share this post Link to post Share on other sites
ashleesmach1 28 Report post Posted September 16, 2016 I thought the nuts came with the kit? Quote Share this post Link to post Share on other sites
Raven R code 281 Report post Posted September 17, 2016 I'm missing 6 nuts for my original shaker trim ring. Quote Share this post Link to post Share on other sites
ashleesmach1 28 Report post Posted September 17, 2016 I'm missing 6 nuts for my original shaker trim ring.Ah ok no problem. Did you find and purchased them? Stupid thumbnails below are not Mine!!!!! Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted September 17, 2016 I just ordered a set and will leave them natural. 1 Raven R code reacted to this Quote Share this post Link to post Share on other sites
Shep69 149 Report post Posted September 17, 2016 Does anyone know if the die cast trim rings are available. My repco Scott drake one is absolute rubbish. The threaded fixing are not even in the right spots . Just a cheap pressed piece of steel. Can't believe I payed $150 for this shit. Very disappointed. Quote Share this post Link to post Share on other sites
ashleesmach1 28 Report post Posted September 17, 2016 Yes they were a few years ago, but I cannot remember where I got it from or how much. I'm sorry. Have searched all the mustang vendors? Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted September 18, 2016 Years ago when I was looking for a ring, and before I repaired mine, these folks had some. No idea of the quality. http://www.fordramair.com/new/products/shakers.htm Quote Share this post Link to post Share on other sites
