69scode 10 Report post Posted November 26, 2014 I am putting my car together and I put the hole covers in with the screws I got with the body kit from AMK. The problem I have is the screws go through the floor and extend down over 1/4". It looks like a good place to cut myself. The easy fix is to grind off the part sticking down, but is this correct? :confused1: Quote Share this post Link to post Share on other sites
Muletman 18 Report post Posted November 26, 2014 I used weather strip adhesive and then put Dynamat over the cover, they aren't going anywhere. Quote Share this post Link to post Share on other sites
1969_Mach1 333 Report post Posted November 26, 2014 Mine are the same way. Luckily, so far I haven't cut myself. Maybe just grind off the sharp point so if you bump into one you won't get punctured. Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted November 26, 2014 I used weather strip adhesive and then put Dynamat over the cover, they aren't going anywhere. Why didn't I think of that? Seriously, how good is good enough? Bob Quote Share this post Link to post Share on other sites
69scode 10 Report post Posted November 26, 2014 Thanks Gentlemen. I did think of glueing them in after I posted. I am putting an insulating mat on the floor as well, so they won't be coming out anytime soon. Now, back to work. :thumbup1: Quote Share this post Link to post Share on other sites
Ridge Runner 1,113 Report post Posted November 28, 2014 They did stick through originally ,about 1/4 inch. The end was blunt . Quote Share this post Link to post Share on other sites