rang-jr 0 Report post Posted October 5, 2019 need help almost got the mach ready to come to life I installed a c4 instead of the fmx and don't know which shifter rod I need do anyone knows what rod i need or do i need to modify one and also can anyone tell me what carburetor bracket do i need to install a holley hp carb on a 351 Cleveland 4v engine Quote Share this post Link to post Share on other sites
Vicfreg 773 Report post Posted October 6, 2019 Hi Rang.... Not sure where you got the C-4 from, there are some variations, so, some things to check: - flywheel diameter, balance weight, and tooth count - driveshaft length - transmission cooling lines - crossmember/transmission mounting bracket(s) - speedometer cable length and speedo gear - shifter rods - dipstick/filler tube location and mounting Quote Share this post Link to post Share on other sites
Vicfreg 773 Report post Posted October 6, 2019 Oh, forgot to try and answer question on the Holley install, need some info.... - Are you putting the Holley on an original Ford Cleveland 4 barrel manifold? - Are you going to use your existing kickdown linkage to the auto transmission Quote Share this post Link to post Share on other sites
rang-jr 0 Report post Posted October 6, 2019 I am using a aftermarket aluminum intake a holley strip dominator 4v intake Quote Share this post Link to post Share on other sites
rang-jr 0 Report post Posted October 6, 2019 10 hours ago, Vicfreg said: Hi Rang.... Not sure where you got the C-4 from, there are some variations, so, some things to check: - flywheel diameter, balance weight, and tooth count - driveshaft length - transmission cooling lines - crossmember/transmission mounting bracket(s) - speedometer cable length and speedo gear - shifter rods - dipstick/filler tube location and mounting the flywheel and drive shaft are correct and in place dipstick was aftermarket and is installed the c4 is out of a mustang i don't know what speedo cable or gear that i am going to need i also don't know what fan shroud and cooling fan i want to use a clutch fan thanks for your help Quote Share this post Link to post Share on other sites
Vicfreg 773 Report post Posted October 6, 2019 Can't help you with the Carb bracket for the street dominator. The Cleveland guys will have to weigh in. That is really a drag race manifold, high rise, single plane. Fan shroud and fans readily available. 2 different widths, depending on whether you have A/C or not. https://www.cjponyparts.com/catalogsearch/result/?q=shroud https://www.cjponyparts.com/catalogsearch/result/?q=clutch+fan Quote Share this post Link to post Share on other sites
barnett468 418 Report post Posted October 6, 2019 See if this 69/70 boss 302 bracket will work for your app. https://www.cjponyparts.com/boss-302-throttle-cable-bracket-1969-1970/p/TCB2/ . . . Quote Share this post Link to post Share on other sites