Dougs Headers with Crossover - Who has them?

[jgkurz 52]

I'm looking to buy a set of Doug's headers for my 1969 FE Mustang. I've seen several comments on the D627 headers but no real installation experience. 

One concern is compatibility with my Canton T-Pan. Thanks for any comments.

[Ridge Runner 1,116]

I did a set of Hooker cross over headers in a 67 Shelby with a 428 ,we used the Cobra t pan .The headers had to set in the engine compartment and installed as the motor was dropped in place .They cleared great and really wasn't to big of a deal installing .I finished bolting them up with the motor lifted slightly or they would have been a pain in the butt to get to some of the bolts .

[jgkurz 52]

I did a set of Hooker cross over headers in a 67 Shelby with a 428 ,we used the Cobra t pan .The headers had to set in the engine compartment and installed as the motor was dropped in place .They cleared great and really wasn't to big of a deal installing .I finished bolting them up with the motor lifted slightly or they would have been a pain in the butt to get to some of the bolts .

 

Thanks for the response. Much appreciated.

[bryonbush 85]

not the same but i have dougs try-ys on my 351w. Wish i would've installed before I put the engine in but they fit in there nicely with the 4R trans

[LindenBruce 27]

Will the Doug's work with the Canton "T" pan?  I thought that was a no?  I would be interested in knowing for sure as well.  B.