Mach1 Driver 560 Report post Posted March 30, 2016 Could one of you 70 Mach owners please measure the width and height of your Mach1 trunk badge? I'm thinking of a stripe and badge change for my 69 Mach but need some dimensions. In the right to left dimension please include the tails on the m and 1 to get the full width. Thanks Quote Share this post Link to post Share on other sites
Mach1 Driver 560 Report post Posted April 1, 2016 ...you know, the x-y dimensions of this thing on your deck lid?? Quote Share this post Link to post Share on other sites
JD08 42 Report post Posted April 3, 2016 From the tail on the m to the outer edge of the 1 is 4.5 inches as is the bottom outer edge of m to the tali of the 1. Of course, that doesn't guarantee those are the factory dimensions because mine's been repainted. Quote Share this post Link to post Share on other sites
Mach1 Driver 560 Report post Posted April 3, 2016 From the tail on the m to the outer edge of the 1 is 4.5 inches as is the bottom outer edge of m to the tali of the 1. Of course, that doesn't guarantee those are the factory dimensions because mine's been repainted. Ok good, what is the height of the "C"? Quote Share this post Link to post Share on other sites
ray1970 88 Report post Posted April 3, 2016 A little up side down...Car has been repainted 6 times not shore how close these are. Needs paint one more time!!! Quote Share this post Link to post Share on other sites
Mach1 Driver 560 Report post Posted April 3, 2016 Thanks, that's just what I needed. I'm contemplating putting one on each side in front of the doors, and doing something different with the stripes. This helps so I can scale it and get it in CAD. Quote Share this post Link to post Share on other sites
Mach1 Driver 560 Report post Posted April 4, 2016 Does this badge use adhesive or pins and clips? JD08's comment makes it sound like its adhesive. The MUSTANG badge on the back now is pins and clips (individual letters) Quote Share this post Link to post Share on other sites