Davib Butler 11 Report post Posted November 28, 2015 I am replacing the rocker panels on my 69 mach 1 with new ones,these are ( not dii ). New front fenders are on, new doors (not dii ) are on, these doors are all so longer by 1/8 , new back fenders ( yes dii ) are on, door gaps front and back are good. Where the rocker panels meat the lower front fender that gap is good. Now here is the problem, the rocker sticks out 5/8 " into the wheel well past the back fender. I have measured alot of 69s and this measurement is 60 and 1/4" ( this measurement is taken from where the rocker meats the lower front fender back to the lip of the wheel well ,do not add in the gap where it meats the front fender ) The ones i have are 60 and 7/8" . Both sides are the same. I don't want to cut to fit . I want rockers that will fit. Did i get some that are stamped out longer ? Please advise. Thank you. 1 Almomam reacted to this Quote Share this post Link to post Share on other sites
Brian Conway 264 Report post Posted November 28, 2015 Mine measure 60 & 1/4". Measured along the top edge and above the anodized aluminum. Brian Quote Share this post Link to post Share on other sites
Ridge Runner 1,113 Report post Posted November 29, 2015 You have 65 -66 rockers ,yes 65-66 are longer .I found this out doing a 65 fast back and i bought 67-68 rockers and they were to short . Quote Share this post Link to post Share on other sites
Ridge Runner 1,113 Report post Posted November 29, 2015 Most vendors do not list 65-66 and 67 -70 as being different .I called Scott Drake and they told me the difference . I added 5/8ths to the end of my rockers to make up the length difference .I have two new Dynacorn rockers for 67-70 and they are the correct length . Quote Share this post Link to post Share on other sites
det0326 179 Report post Posted November 29, 2015 Check the width also, I purchased a 69 Dynacorn rocker the length was ok but the width from the inside to outside was to wide. If I remember correctly the tray where the harness lays was wider than OEM i wound up using the repo to patch the original. Dave Quote Share this post Link to post Share on other sites
Ridge Runner 1,113 Report post Posted November 29, 2015 I compared a driver Dynacorn rocker with an original 65 rocker ,you can see the difference .With the 69 over laid the 65 sticks out about 5/8 -3/4 inch .the door point on both rockers is the same I measured my Cj rocker and from the door point to the end of the rocker is 60 1/4 .i measured the Dynacorn rocker and it is exactly the same. I measured side width on my CJ and it is 4 1/4 ,the Dynacorn is the same . The only difference in the two rockers is the extension is made on to the Dynacorn rocker .It can be cut to the proper length if the extension does not need to be removed ,the rocker will simply overlay the original extension Quote Share this post Link to post Share on other sites
Brian Conway 264 Report post Posted November 29, 2015 Well that's kinda a pisser ain't it. Quote Share this post Link to post Share on other sites