msd 8584 install question

[bryonbush 85]

So i was looking at the wires sticking out the dis and noticed that it looks like its supposed to plug into an MSD box. But i dont have a box and wasnt really planning on getting one any time soon. So how to i hook it up to a factory set up? 

[Grabber70Mach 107]

MSD Ford Billet Distributors

PN 8473: 2.3L, PN 8580: 351C, 351M, 400, 429, 460

PN 8582: 289, 302, PN 8584: 351W

PN 85805: 351W w/Edelbrock Victor Jr. Intake

Important:  Read these instructions before attempting the installation.

Note:An MSD Ignition is required with this Distributor.

Parts Included:

1 - Billet Distributor

1 - Rotor

1 - Distributor Cap

Note:These distributors must be used with an MSD Ignition Control.

TIMING FUNCTIONS

Before continuing with the installation, here are a few definitions you should be aware of:

Initial Timing: This is the base timing (also referred to as idle timing) of the engine before the

centrifugal advance begins.

Centrifugal Advance: The centrifugal (or mechanical) advance mechanism is made up of weights,

springs, advance cams, and an advance stop bushing. The amount and rate of advance that your

distributor is capable of is determined by the centrifugal timing. If you ever wish to lock out the

centrifugal advance, refer to the centrifugal advance section.

Total Timing: This is the total of the initial timing plus the centrifugal advance added together.

Example: 10° Initial + 25° centrifugal = 35° Total Timing.

Note: MSD Distributors are supplied with the heavy (slow) advance springs installed. This is to

prevent detonation in certain applications. Review the information on pages 2-4 to determine

the best advance curve for your application.

1-Advance Kit

1 - Tube of Gear Lubricant

1 - O-Ring

WARNING: Before installing the MSD Distributor, disconnect the battery cables. When disconnect-

ing the battery cables, always remove the Negative (-) cable first and install it last.

MS D I GN I T I ON • www.msdignition.com • (915) 857-5200 • FAX (915) 857-3344

 

Apears the installation instructions say you need to use the msd ignition.

[Protowrxs 111]

Or some kind of electronic ignition box such as the Ford units from the 80s or around there. Obviously MSD gives you the multi spark though. Have to have something to take that trigger and process to fire the coil.

 

Protowrxs