-mikko- 10 Report post Posted May 3, 2014 I am currently replacing battery side inner fender => replacement panel seems to sit too low with my new radiator support :ohmy: It seems that when you look at it from front to back shock tower is higher, it makes some sort of curve (hope you understand what I mean...). Is that top line of inner fender supposed to be straight line? If I put it straight there is cap between frame and bottom of this panel => it seems to be too short :thumbdown: Can someone measure distance between frame rail (top) and radiator support at highest point where that inner fender is welded? Thanks allready:yes: Quote Share this post Link to post Share on other sites
Mike65 476 Report post Posted May 4, 2014 If I put the end of the tape measure on the top (in the engine compartment) of the passengers side frame rail & measure to the top lip of the front inner fender panel where the fender bolts to mine reads 17 1/4". Quote Share this post Link to post Share on other sites
mustangstofear 608 Report post Posted May 4, 2014 You could just bolt the panel on the top and see how it fits. Then if it looks right tack weld it in place. Quote Share this post Link to post Share on other sites