9350 10 Report post Posted April 4, 2009 I just installed a new front crossmember from www.cobraautomotive.com . They put them on all of their competition cars and it greatly reduces the front end flex. It's a nice powdercoated piece that ties into the lower control arm bolt. It's a big improvement over the old tube it replaced. Quote Share this post Link to post Share on other sites
fordtj69 10 Report post Posted April 4, 2009 hi 9350 have you got a photo of it fitted i just got a price off them to send one downunder thanks for posting the side by side shot thanks tim Quote Share this post Link to post Share on other sites
9350 10 Report post Posted April 4, 2009 This is a picture looking up at the lower control arm bolt. The black bolt on the right is the one that goes into the frame. Not a very good shot, but it's all I have. Quote Share this post Link to post Share on other sites
xplane 10 Report post Posted April 5, 2009 Depending on the steering setup I use, I am definately looking into one of these. What do they get for one? No prices on there website... Mike Quote Share this post Link to post Share on other sites
RogerC 136 Report post Posted April 6, 2009 Or you could modify your stock one according to the Boss 302 Chassis Modification book and save a few bucks. Quote Share this post Link to post Share on other sites
stangme428 33 Report post Posted April 6, 2009 This is a picture looking up at the lower control arm bolt. The black bolt on the right is the one that goes into the frame. Not a very good shot, but it's all I have. interesting, i have all of the pro-motorsports kits installed on my car. this would seem to tie in very well with the eccentric eliminator kit. hope to have my car on the road soon, i may pick one of these up before the motor goes in. thanks for the post:tongue_smilie: Quote Share this post Link to post Share on other sites
xplane 10 Report post Posted April 6, 2009 Or you could modify your stock one according to the Boss 302 Chassis Modification book and save a few bucks. Thanks for the info X! Quote Share this post Link to post Share on other sites
dennyb68 11 Report post Posted April 7, 2009 looks like the big question is how much $$$$$$$ did you have to shell out for that fine piece? Quote Share this post Link to post Share on other sites
RogerC 136 Report post Posted April 7, 2009 looks like the big question is how much $$$$$$$ did you have to shell out for that fine piece? A minute or so on the site and it looks like its $195+ shipping. Quote Share this post Link to post Share on other sites