Gauge Pod

[guigui 114]

whoaw what a very rare option it si !!

 

these tach look very nice

 

i 've seen found an ads on these ford items

[Pakrat 1,043]

Hey John, how did you take it apart anyway? After taking a closr look at mine I notice I can see a slight finger print on the inside of the lens that I'd like to be able to clean off if I can do so without detroying it.

[Kiwi John 10]

Hey John, how did you take it apart anyway? After taking a closr look at mine I notice I can see a slight finger print on the inside of the lens that I'd like to be able to clean off if I can do so without detroying it.

 

 

Hi Pak,

It's a piece of cake to take apart.

Remove the two small screws on either side of the big nut then screw out the big nut underneath that the wires exit through, then put your finger up inside just through the case and push on the threads outwards to slide the whole guts out.

Unclip the face plate (black) by gently lifting the tangs, be careful cause these break of easily. You will then see 4 (I think) screws that hold the outside lens in place, remove these and lift of the lens, there will be a robust rubber gasket underneath.

 

Hope this helps.

John