Jump to content

Her69fastback

Members
  • Content Count

    189
  • Joined

  • Last visited

Posts posted by Her69fastback


  1. I’m going to replace the brakes on the 69. The  car has manual brakes. This is my wife’s car. She doesn’t like driving it because of the brakes. I have talked to wilwood they said go with 7/8 bore master cylinder. Or should I just do power brake booster? Does anyone’s wife drive a car with a 7/8 bore master cylinder and think it stops great or would rather have power brakes?


  2. 58 minutes ago, Mach1 Driver said:

    ep, as Mid says, its probably the neutral safety. Power comes from the battery, goes through the ignition switch, through the neutral safety and to the starter solenoid. If the solenoid doesn't even click, then it is either the ignition switch, the neutral safety, or the wire connections somewhere along the line.

    This is a schematic, not a wire diagram:

    image.thumb.png.9b49bb06a2c9356c845ae763d2a51498.png

    Below is the exact circuit, but in wire diagram form. The schematic is intended to show how it works, and the wire diagram shows you how to wire the car. Most people find the schematic much easier to read.

    image.thumb.png.8f8b61b1e3b1dfd1feab62f2d4aa6a59.png

     

     

    Thank you


  3. I put a new neutral safety switch when I put in the transmission. I have tried moving the shifter. I even put it in gear & in neutral. With no change. I can get out & put it across the solenoid & it will start ever time. It doesn’t happen all the time. That’s what’s driving me crazy. 
    thanks for the help


  4. I replaced the starter, starter solenoid & the ignition switch. You turn the key & you don’t get anything. Then other times it will start. This car used to be  3speed car. I put a automatic in it . I left the stock pedals  in the car. Is there a switch I need to take out or something else I’m missing?  Thanks for the help
     


  5. To all the wiring gurus. I have everything wired & to car runs. I’m trying to figure out the double fan wiring. I have 2 relays on the way. I have 2 electric fans. The Holley snipe will control the fans. What’s confusing me is they say the Light blue  & light green wires are output connect to relay ground trigger. I’m a dummy when it comes to wiring. I have searched the wed & it’s more confusing. I found this pic & I think this is how I need to do it. I want someone that’s knows a lot more then  me to look at it.

    6BFDC220-BC07-4508-A3F7-620323F1CDB1.png

×
×
  • Create New...