69 red fastback

Sounds good

Thanks, we have a hotel room, i don't know a lot about biloxi yet, which casino are you talking about, we're not to far from the beau rivage

Hey Mikestang where are you guys going to be hanging out, I'm dying to see the hood that RidgeRunner made

Thanks for the response, I'm going to put on a carb spacer tomorrow night when I get home and then I'll check for vac leaks

Thanks, I'll give it a try

Well I did what Regta advised and I am getting gas when I work the throttle, so if the accelerator pump is working what else could cause the hesitation

Thanks for the reply, I'll check that tomorrow and see if it is shooting gas like you said, I assume if that is the problem the AP is easy to come by

I have a holley 4150 600 cfm and when I give some throttle it stumbles and then it will take off. My thought is the accelerator pump, but I'm not the best on carbs, any thoughts from the people on here that are carb pros would be greatly appreciated

I glued mine in with those measurements and it worked out perfect,so thanks again guys for the measurements

I've been thinking of going to power windows, but now I have to wait until I get my wifes 65 coupe done, I'm getting it blasted tomorrow then on to a little rust repair

Thanks guys I really appreciate it

I get it now, yeah I'm not the smartest tool in the shed, but what you said makes perfect sense.I've got some old tubes laying around so that's what I'll do. Thanks again for the help, much appreciated, P.S. I've got one more guestion, in the video he said put the bracket an inch from the end of the glass. Is that the same for mustangs as well?

Thanks for the reply, I'd like to ask though, what are the shims for that you talked about

I had the glass on my passenger side door come loose yesterday, and I was wondering what is the best adhesive and the best way to get it glued back in. Thanks in advance for any help

Also what I like about it is you never have to change it, if you have to work on something just drain it into a clean jug, and when you're done just put it back in

I haven't noticed it at all, it's been running pretty much normal, I'm running an aluminum radiator also and it stil looks brand new inside

I'm using it and have no problems at all, just make sure you get everything clamped down good, it's to expensive to poor it on the ground, also I bought my kit off of ebay and saved several bucks

Thanks for the reply

I've got a stupid guestion here. So I need to change the pan gasket on the tranny and was wondering what the torque specs are on the bolts and also the sequence for tightening them up. Thanks in advance.

Thanks for the info, I think I'm gona give it a try

Has anybody used one of the hidden antenna's for their car, I didn't put mine back on the finder, and was wondering if the hidden ones worked or if they're a waist on money. Any info would be greatly appreciated.

Thanks for the info

Thanks for the info

Thanks guys for all the info, much appreciated

Thanks guys for all the info, much appreciated