Jump to content

austin

Members
 View Profile  See their activity

  • Content Count

    4

  • Joined

  • Last visited

Community Reputation

10 Good

See reputation activity

About austin

  • Rank
    Newbie
  • Birthday 06/05/1959

Converted

  • Biography
    Mechanically inclined DIYourselfer
  • Location
    Ottawa,Ont.Canada
  • Interests
    Saving 69 Mustangs
  • Occupation
    Truck Driver
  1. austin
    I just notice the date disregard you probally figure it out by now
  2. austin
    you need to drill the torque box if it doesn't have an oblong hole beside the fuel line hole I am not sure how to send picture other than e mail
  3. austin
    the e-brake goes through the torque box drill 2.5 from firewall and 1.5 from side this will get you inside of torque box then fish wire where gas line goes and i drilled a holes about 1.5 from it just line up a straw to see where the cable would be there was no holes in my new torque boxes either. step down drill bit and angle driill is what i used. I am new to this site not sure if i am doing it correctly
  4. austin

    I am new to this so i am not sure how to navigate trough this page yet looking for photo or info on how to route an ebrake cable it seem that they blocked the hole in the floor I would appreciate some infoor link unfortuately my car is in canada so too late to start over with a better shell from california

  5. austin

    I am new to this so i am not sure how to navigate trough this page yet looking for photo or info on how to route an ebrake cable it seem that they blocked the hole in the floor I would appreciate some infoor link unfortuately my car is in canada so too late to start over with a better shell from california

  6. austin

    I am new to this so i am not sure how to navigate trough this page yet looking for photo or info on how to route an ebrake cable it seem that they blocked the hole in the floor I would appreciate some infoor link unfortuately my car is in canada so too late to start over with a better shell from california

  7. austin
    just got the torque boxes in and i don't know where the ebrake cable is suppose to go through, they didn't keep the original hole I am looking for a picture or instructions :bored:
×
×
  • Create New...