Dave R. 85 Report post Posted September 25, 2016 After making a right hand turn my turn signal switch cancels as it should but most of the time travels to far and turns on the left turn signal. Any thoughts? Is the switch bad or in need of a little grease? All works as it should when I signal for a left turn. Thanks. Dave R. 3 WilliamFug, JoryikRet and JefferyPt reacted to this Quote Share this post Link to post Share on other sites
LindenBruce 27 Report post Posted September 25, 2016 The plastic cam inside under the steering wheel may have been damaged due to age. Pull the wheel and take a look to see what is going on. B. Quote Share this post Link to post Share on other sites
Dave R. 85 Report post Posted September 25, 2016 Thanks B. The switch feels ok when I move the lever but I guess it is worn. I'll put that on my "off season to-do list". Dave R Quote Share this post Link to post Share on other sites
LindenBruce 27 Report post Posted September 25, 2016 Yep. Here is a pic of the cam that usually fails. Quote Share this post Link to post Share on other sites
LindenBruce 27 Report post Posted September 25, 2016 And the switch with cam. Quote Share this post Link to post Share on other sites
Dave R. 85 Report post Posted September 25, 2016 So the cam can be replaced by itself? Guessing that the switch is original, 48 years next month, I think a replacement switch is the smart move. Thanks again Bruce. Dave R. Quote Share this post Link to post Share on other sites
danno 128 Report post Posted September 25, 2016 I might have an extra cam if you want to just replace it. Otherwise the whole thing is probably due for replacement. 48 years... Quote Share this post Link to post Share on other sites
Dave R. 85 Report post Posted September 25, 2016 Thanks for the offer danno. I'll keep that in mind when I pull the wheel and see just what I have in there. Dave R. Quote Share this post Link to post Share on other sites
LindenBruce 27 Report post Posted September 26, 2016 Yeah, unless you have a Thoroughbred class car, you might want to replace the whole switch as apposed to just the cam. Which, yes, can be changed separately. B. Quote Share this post Link to post Share on other sites
Dave R. 85 Report post Posted September 26, 2016 Leaning that way Bruce. I appreciate your input. Dave R. Quote Share this post Link to post Share on other sites