sidstang 10 Report post Posted December 21, 2014 Hi, I bought a basket case 69 Mustang and am putting in the 302 engine that came with it. But, I don't have the bolts. I would like to get them from the local hardware store, but don't know the sizes and lengths. Can anyone tell me what size & length are the: Eng - AT Trans bolts Starter Bolts Bolt that holds the motor mount together Crossmember bolts Help would be much appreciated! Thanks! Sid Quote Share this post Link to post Share on other sites
jholmes217 65 Report post Posted December 22, 2014 I recommend you just buy a engine bolt kit and engine mount kit from AMK. Here's a link to AMK. http://www.amkproducts.com/Ford_Master_Kits.asp Quote Share this post Link to post Share on other sites
barnett468 418 Report post Posted December 22, 2014 (edited) . if you need them right away the following will work...maybe: bell housing to eng = 7/16" x 1 5/8 with lock washer motor mount to eng = 7/16" x 1 1/4" with lock washer. starter to eng = 3/8" x 1 3/8" with lock washer. trans mount to trans = 7/16" x 1 3/8" with lock washer. take these pieces to the store to confirm size . . the bolt should just barely fit in the holes/ motor mount to frame = 3/8" x around 3 1/2" with 2 flat washers 1 lock washer and 1 nut. Use grade 8 washers. cross member to frame = 3/8" x measure the width of cross member. trans mount to cross member n= 7/16 nut lock washers and grade 8 flat washers and 2 standard grade 5 washers with a large outside like fender washers . . Edited December 22, 2014 by barnett468 Quote Share this post Link to post Share on other sites
sidstang 10 Report post Posted December 23, 2014 .if you need them right away the following will work...maybe: bell housing to eng = 7/16" x 1 5/8 with lock washer motor mount to eng = 7/16" x 1 1/4" with lock washer. starter to eng = 3/8" x 1 3/8" with lock washer. trans mount to trans = 7/16" x 1 3/8" with lock washer. take these pieces to the store to confirm size . . the bolt should just barely fit in the holes/ motor mount to frame = 3/8" x around 3 1/2" with 2 flat washers 1 lock washer and 1 nut. Use grade 8 washers. cross member to frame = 3/8" x measure the width of cross member. trans mount to cross member n= 7/16 nut lock washers and grade 8 flat washers and 2 standard grade 5 washers with a large outside like fender washers . . Thanks a lot Barnett468! That is what I needed. Sid Quote Share this post Link to post Share on other sites