malcolm300 10 Report post Posted September 22, 2014 not sure if anyone can help, i got all my c4 in and filled up and with the car on axel stands went through the gears all seemed well untill i realised that the propshaft spins the same way in revers as it dose in the forwaed gears! anyone know what this might be? do i need to adjust the bands? Quote Share this post Link to post Share on other sites
malcolm300 10 Report post Posted September 23, 2014 any ideas? Quote Share this post Link to post Share on other sites
Rsanter 152 Report post Posted September 23, 2014 The reversing band in the trans is not applying Bob Quote Share this post Link to post Share on other sites
malcolm300 10 Report post Posted September 23, 2014 thats what i though i dropped the valve body today and checked the servo with air it seems to come on fine. i also adjusted the band in but i didnt hav a small enough tourqe wrench so had to guess. do you think it need to come in more?? also the car is still on stands and i havent really let it get to temp only running the car for short periods due to it being inside do you think its worth taking it outside and letting it warm up and see what it dose?? Quote Share this post Link to post Share on other sites
Rsanter 152 Report post Posted September 23, 2014 Tempature is not an issue Getting all the air out of the passage ways in the trans is, but it seems like you have done that Stupid question Are you suer both tires were spinning foreword? Do you have an open rear end? Bob Quote Share this post Link to post Share on other sites
malcolm300 10 Report post Posted September 23, 2014 To be honest I have been looking at the prop as I didnt want to get confused by the axle! Like I said I suppose I can only be sure when the car is on the ground. Im going to adjust the bands again and also check the reverse servo as when I did the air test the bands did move but they did not fully close Im not sure if this is an issue or not? Quote Share this post Link to post Share on other sites