Nightowl 10 Report post Posted August 10, 2012 (edited) Does anyone have a picture of where the switch and how it is mounted on the transmission for a top loader 4 speed? I can't remember if there was some sort of bracket that was used to hold the switch. I believe there was something there that held that switch to the tranny. I am going to install the Hurst shifter, and take the Mr. Gasket vertical gate shifter out. Thanks. :001_smile: Edited August 10, 2012 by Nightowl Quote Share this post Link to post Share on other sites
Flanders 47 Report post Posted August 10, 2012 hopefully someone can post a pic sooner, but if not, I can snap a pic of mine once it's back from the garage (early next week). 4 spd toploader with Hurst. Quote Share this post Link to post Share on other sites
LoneWolf2U 136 Report post Posted August 10, 2012 Hurst backup lamp switch installed. I posted this once before but don't know where it went. Quote Share this post Link to post Share on other sites
Nightowl 10 Report post Posted August 10, 2012 That would be great. :001_smile: Quote Share this post Link to post Share on other sites
Flanders 47 Report post Posted August 10, 2012 Mach1Rider's looks just like mine! :) Quote Share this post Link to post Share on other sites
Nightowl 10 Report post Posted August 11, 2012 The 2 wires on the switch go to where? The plug behind the engine that has a wire loop in it? Quote Share this post Link to post Share on other sites
69gmachine 15 Report post Posted August 11, 2012 Yes, that's the plug. Quote Share this post Link to post Share on other sites
LoneWolf2U 136 Report post Posted August 11, 2012 The 2 wires on the switch go to where? The plug behind the engine that has a wire loop in it? They connect to the black/red wires of the square 4 plug at the firewall. Quote Share this post Link to post Share on other sites
Nightowl 10 Report post Posted August 11, 2012 Thanks. :smile: Quote Share this post Link to post Share on other sites
