elcristobal 10 Report post Posted June 22, 2010 so i just finished installing my new hookers. In the process i disconnected wires and plugs. when i plugged everything back in my engine is just turning but it will not start. It started perfectly fine before the install, any ideas. fuel is there all plugs and wires are good. Thanks Quote Share this post Link to post Share on other sites
elcristobal 10 Report post Posted June 22, 2010 so i just finished installing my new hookers. In the process i disconnected wires and plugs. when i plugged everything back in my engine is just turning but it will not start. It started perfectly fine before the install, any ideas. fuel is there all plugs and wires are good. Thanks Quote Share this post Link to post Share on other sites
69again 10 Report post Posted June 22, 2010 If it is turning over and not sounding like it is trying to start, back fires, misses, then it is likely the coil wire to the ignition or coil to distributor. If it is trying to start, check your coil to distributor and go over all the plug wires again. Since it ran fine before, it should be an easy fix. dan Quote Share this post Link to post Share on other sites
69again 10 Report post Posted June 22, 2010 If it is turning over and not sounding like it is trying to start, back fires, misses, then it is likely the coil wire to the ignition or coil to distributor. If it is trying to start, check your coil to distributor and go over all the plug wires again. Since it ran fine before, it should be an easy fix. dan Quote Share this post Link to post Share on other sites