jag 10 Report post Posted November 21, 2008 I have a Torino shaker base. I want to use it with an original shaker upper half and an original Ford 4 bbl intake. I have been told that the Torino base is taller than the correct mustang base. Can anyone tell me how much taller or what the correct height on a stock Windsor base might be? If someone has done this before, I would take any and all recommendations. Thanks JAG Quote Share this post Link to post Share on other sites
BuckeyeDemon 211 Report post Posted November 21, 2008 The Boss 302 site has some nice information about shakers. http://www.boss302.com/shaker.htm Quote Share this post Link to post Share on other sites
jag 10 Report post Posted November 22, 2008 Thanks for the reply BuckeyeDemon. I had found that page and my bottom does look like that. However two of the three studs are out of position. That is not a big problem. I measured my base and from the bottom to where the shaker mid plate sits and it is 4.25 ". That dimension does not fit any dimension on the Boss 302 site. I was hoping someone could measure their shaker base from bottom to the flange where the mid plate sits and give me a dimension. That will let me know what I have to do to this shaker bottom. JAG Quote Share this post Link to post Share on other sites