Hemi Hunter 10 Report post Posted May 31, 2007 looking from someone who can give me the correct 351 badge placment on my non ram air hood scoop. I've got to drill the holes and want to be sure its as close to factory as possible. As always you guys are a great reference. Share this post Link to post Share on other sites
PaleRider 12 Report post Posted May 31, 2007 Mine is 6.5" from very tip of scoop to first hole and about 7/8" from bottom to center of hole. My scoop is original. I'm assuming badges are too. Mine has chrome badge holder that the badge sticks on to. Is the at the same as yours. Would like to find new badge holder put have not seen them in any catalog. Mine are pretty pitted. Share this post Link to post Share on other sites
d.reese 13 Report post Posted May 31, 2007 Great question, I will need that also! Can anyone else add input to confirm these dimensions? Share this post Link to post Share on other sites
Hemi Hunter 10 Report post Posted June 1, 2007 Mine is 6.5" from very tip of scoop to first hole and about 7/8" from bottom to center of hole. My scoop is original. I'm assuming badges are too. Mine has chrome badge holder that the badge sticks on to. Is the at the same as yours. Would like to find new badge holder put have not seen them in any catalog. Mine are pretty pitted. I actually ordered mine through virginia classic mustang @ http://www.virginiaclassicmustang.com/catalog/shop/ Little pricey at 23.00 bucks each but remarkably accurate repros. Same (chrome backing with a stick on label) you can order 351 - 390 or 428 badges and they come with the fasteners. Share this post Link to post Share on other sites