600cfm Holley Carb fuel line photos needed.

[*JackBurton* 0]

I've got a 1460 600cfm style holley 4bbl on my mustang. I would like to see some photos of how you guys have your fuel line hooked up. I'm using stainless steel line made for a 351 for a 69 4bbl from the fuel pump to the carb but it doesn't seem to line up right. My guess is that the line is setup for an autolite carb thus I'll have to rebend it.

 

I also need a reference pic of the throttle cable, bracket, and return springs.

 

Thank you in advance for the help.

 

Sean

 

Here is the style of carb:

http://www.holley.com/data/products/pictures/large0-1850C.jpg

[Thunder Kiss 13]

Here's mine:

 

[*JackBurton* 0]

That is perfect. I was thinking about cutting the stainless line back enough for the fuel filter and then flaring it. On the throttle cable what hole is it hooked into on the carb?

 

Thank you again for the pic.

[FMACHI 10]

I can get you pics if you like, I did mine almost the same way. I have an elbow coming out of the Holley pointing towards the fuil line. I cut the fuel line a little lower and joined it with a piece of fuel hose. I put my inline filter in as the line comes through the inner guard. It's down low, so it's out of sight.

David

 

PS hows life in Geelong treating you. Still have to fit the Magnums to the Stang.

[*JackBurton* 0]

Here is where I'm at right now with this project. I think I'll head back to Earls and pick up a 90deg fitting.

 

 

[Thunder Kiss 13]

Hi FMACHI, All is well here. I'm kicking myself a little because I think the 215/60-15's I have on the front of my car are one size too small, I want to go to 225/60-15 but I sold my 225's didn't I?

 

On the throttle cable what hole is it hooked into on the carb?

Here's a close-up of the linkage: