Turn Signal/Ignition Switch Wiring Harness Routing - 1970FB

[TomM 25]

I have a 70FB, non-tilt steering column.  I am trying to determine the correct routing of the turn signal and ignition switch wiring harnesses. 

1) Currently the turn signal wiring is at 6:00 position on the column but this will cover the area where the trim shroud clip attaches to the column.  Do I just push the wires aside to install the clip or should the harness be at more like 3:00 to get it above the support-to-column bolts on either the inboard or outboard?

2) The ignition harness connector mounts on a metal tang just behind the dash - does the harness go as shown in the pic or does it get routed between the support bracket and the column?

I have the shop manuals, I just don't see a good routing diagram.

Thanks, Tom