jeepcj7304 10 Report post Posted December 14, 2012 I am putting the 69 back together after getting it painted and I placed the rubber fender extension seals in the front and back but they look odd. They are really hard to miss since they create a large black line around the extensions. Does everyone else use these or not? I attached a picture below. Quote Share this post Link to post Share on other sites
06minx09 10 Report post Posted December 14, 2012 You have them installed wrong. The seal goes on the the head light bucket and is compressed and is invisible when bolted to the fender. It is a specific shaped squared U channel seal and one side of the U is slightly longer than the other. There is a edge in the bucket that fits in the U of the seal. Hope this helps. Quote Share this post Link to post Share on other sites
Chelby-Ann 47 Report post Posted December 14, 2012 You have to have them installed the wrong way. I just installed them and they do not stick out. Its easy to install them the wrong way if you dont know. No worries. Just reverse them and you'll be much happier Quote Share this post Link to post Share on other sites
Cruzzar 22 Report post Posted December 15, 2012 If I recall correctly you will have to cut a notch out of one side of the u-shaped seal so it will fit around the studs properly. Quote Share this post Link to post Share on other sites