Chelby-Ann 47 Report post Posted November 16, 2012 So after I installed the mounting screws into the headlight bucket, I noticed that one area was missing a tab with a hole in it. I decided to make a bracket and JB Weld it to the bucket. Did not look like it carried a lot of load so I figure this might be a good repair. I also noticed I was missing some nut plates? from the back of one of the buckets. If anyone has 4 of them lying around the garage taking up some room, I'll take them off your hands. Plan on mounting the headlight buckets on the fenders this weekend. Quote Share this post Link to post Share on other sites