493dart 11 Report post Posted October 4, 2011 Has anyone ever put a seal kit in a power steering rack / cylinder on a 69? is it difficult ? special tools needed ? Quote Share this post Link to post Share on other sites
Desert_69 11 Report post Posted October 4, 2011 I just did mine, no special tools needed other than some sharp screwdrivers. Make sure you get a good diagram as to how it should all go back together. It's kind of tedious pulling all of the old seals out, mine came out in chunks. Quote Share this post Link to post Share on other sites
LoneWolf2U 136 Report post Posted October 4, 2011 Has anyone ever put a seal kit in a power steering rack / cylinder on a 69? is it difficult ? special tools needed ? The slave cyl seals are not too hard to replace. Best tool to have is a sharp pointed awl to remove the inner seals and washers, Using a angled twisting(unscrewing) motion. Just lay out the parts in a line as you remove them and match the new parts to them so it is easier to reassemble. Quote Share this post Link to post Share on other sites
493dart 11 Report post Posted October 4, 2011 ok thanks guys- Quote Share this post Link to post Share on other sites
