6T9rustang 11 Report post Posted July 20, 2008 When you guys remove or fit your engines with the tranny connected to the motor, do you remove the tubed cross member down below the engine mounts or can that stay in place? The reason I'm asking is because i'm looking at beefing the cross member up and making it a permanent welded thing. But if it hinders the engine removal/fitting then I won't make it permanent. Quote Share this post Link to post Share on other sites
6T9rustang 11 Report post Posted July 20, 2008 When you guys remove or fit your engines with the tranny connected to the motor, do you remove the tubed cross member down below the engine mounts or can that stay in place? The reason I'm asking is because i'm looking at beefing the cross member up and making it a permanent welded thing. But if it hinders the engine removal/fitting then I won't make it permanent. Quote Share this post Link to post Share on other sites
Justafordguy 10 Report post Posted July 20, 2008 I left mine in place when I installed the engine/tranny and it went in fine. Quote Share this post Link to post Share on other sites
Justafordguy 10 Report post Posted July 20, 2008 I left mine in place when I installed the engine/tranny and it went in fine. Quote Share this post Link to post Share on other sites