Horns

[Cam3512 10]

I just picked up a pair of original horns. The PO had one cheap aftermarket plastic 'hi' tone, and that was it. When connecting the new 'hi' and 'lo' horns, exactly how is this done? There's a spade connector on each, and that appears to be it. Is there a ground connection? There are two small screws, one on each. What are these for? Silly question, but someone please enlighten me!

[69grandecj 0]

The screws are to adjust the pitch of the horn. If you still have the correct wiring they should just plug in. The will bolt to the radiator support, one to each side of the hood latch support.

[Spoofty 10]

When connecting the new 'hi' and 'lo' horns, exactly how is this done? There's a spade connector on each, and that appears to be it. Is there a ground connection?

 

They ground through the actual horn bracket where they bolt to the car. So only one wire is needed.