magician
-
Content Count
153 -
Joined
-
Last visited
Posts posted by magician
-
-
Need AC idler for my 351 w...with good bearings
-
No, not yet. I put one in another car I rewired,. I may have a pix of it. I cut a relay box out of a crown Vic and put in the mustang before I found this. Replacing It with this one in the near future. I ran lights,horn,fan off relays . set half of fuses to 12v ignition ,half to constant hot.
-
-
You can shim the fenders also to split the difference
-
Cross them over at about 2-2.5 k
-
I imagine that double speaker tilted towards each-other would sound bad no? battling frequencies or what ever?
Not always....yorkville audio uses this configuration in their very popular low end cabinets for commercial audio..the real concearn would be the lack of baffles surrounding the speakers. Waves coming off the front and back would mingle causing a loss of low frequency. It also contributes to serious loss of power handling capabilities
-
Email scotty at smsmustang@ yahoo.com. he may have a couple
-
While your at the radio plug, grab the dimmer to
-
Not that big a deal to do. I had a 70 in my 69 for years before going back original.
-
A lot of wire hype is bs. Good quality wires will work on anything
-
That isn't big enough. The 60 should be. Filters and dryers are mandatory also. The gun you choose will tell how much air you need.
-
Email scotty at sbsmustang@Yahoo.com..He's parting out a few
-
Hook a drill to the cable and watch Speedo.
-
Big debate over filler under or over epoxy...either way works...do as the tech sheet says for your brand.....
-
I would epoxy prime it then filler work..if you remove it be patient. Don't heat warp the metal around if.
-
If no one chimes in I'll get my wiring diagram tonite and see if I can help
-
What kind of brakes do you have...power brakes may be an issue
-
-
Sounds like a plan...good luck!
-
Is the paint urethane or enamel? Both are available as 2k. If urethane, yes it would probably work. As stated, test on junk panel first.
-
Why do you need factory diagram if you are running a painless harness?
-
-
Granada spindel geometry is not an issue on 69-70.
-
What's a radio ?
Thoughts on how to metal work this door
in 1969-70 Technical Forum
Posted · Report reply
Weld a welding rod down the crease..grind to contour.