Dangstang 14 Report post Posted March 29, 2013 Installed front suspension with engine in the car and for some reason the front of the car sits higher than the back.I know there could be a couple reasons for this.Any ideas as to how it could be lowered maybe a 1" or 1 1/2"? Quote Share this post Link to post Share on other sites
lseann 10 Report post Posted March 29, 2013 Just replaced my front end as well. If you used a stock style lca, did you remember to not torque down the frame mounts until the weight of the car was on them? Quote Share this post Link to post Share on other sites
Dangstang 14 Report post Posted March 29, 2013 might be the issue as the car was returned from paint as a roller with lower Arms already installed.What the fix loosen then re torque? Quote Share this post Link to post Share on other sites
lseann 10 Report post Posted March 29, 2013 I'd prob jack it up to take the weight off, loosen, then let it back down then torque to spec. Before you torque to spec maybe roll the car backwards a few feet then fwd a few feet to let the front end settle. I put Global West LCA's on my car and they have spherical bearings instead of the rubber/bushing combo so with mine, tightening those bolts is ok with car on jackstands. If you have the eccentrics on there, make sure and take note of where they are prior to loosening/retightening. I used eccentric eliminators. Quote Share this post Link to post Share on other sites
miketyler 15 Report post Posted March 30, 2013 (edited) If after all that you still need to drop the front, you might consider the Shelby/Arning drop. Edited March 30, 2013 by miketyler Quote Share this post Link to post Share on other sites
Dangstang 14 Report post Posted March 31, 2013 just looked into the Shelby drop,thanks for throwing it out their Mike otherwise might not have looked at it for a option.Also looking at changing out my front springs to lower slightly.Any suggestions for a spring that would be suitable for performance street driving? Quote Share this post Link to post Share on other sites
dennyb68 11 Report post Posted April 1, 2013 I had to cut off almost a full coil on my springs to make it the way I wanted it. I also did the Shelby drop but that wasn't enough. Quote Share this post Link to post Share on other sites