69mustang351W 0 Report post Posted August 12, 2010 Winter 2008/2009 I was removing the front bumper and brackets for make bigger holes in the brackets to lift the bumper a bit. It became a bit better but not very much better. The centre of the bumper is ok, but I still mean the sides of the bumper point a bit to much down. One image is attached and under the outer light on the drivers side it shows that the bumper is some millimiters to much down. Next winter I may be removing the bumper and fasten it to something and try to bend the sides a bit up. Not much but just a little. The front bumper is a repro bumper, so its maybe easier to bend. Someone have some experience with bending bumpers? It may look something specially to do this, but it is a possibillity to get it as I want. Quote Share this post Link to post Share on other sites