T5 swap question.

[sj9ers 10]

I'm swapping a roller 302 with a late model bell housing and t5 into my mustang. I'm using the yoke that came with the t5 and was wondering if i have to shorten the drive shaft? If so by how much? If it matters I originally had a c6 in the car and a 9 inch rear end.

Thanks

[sj9ers 10]

I'm swapping a roller 302 with a late model bell housing and t5 into my mustang. I'm using the yoke that came with the t5 and was wondering if i have to shorten the drive shaft? If so by how much? If it matters I originally had a c6 in the car and a 9 inch rear end.

Thanks

[dennyb68 11]

The only way to know how much is to measure it and see put the yoke in the trans a pull it out 1" then measure the distance from the center of the bearing cup to the rearend yoke.

[dennyb68 11]

The only way to know how much is to measure it and see put the yoke in the trans a pull it out 1" then measure the distance from the center of the bearing cup to the rearend yoke.