Jump to content

Archived

This topic is now archived and is closed to further replies.

Boogerschnot

Body work and primer..

By Boogerschnot, in The Garage

Recommended Posts

Boogerschnot    12

Boogerschnot
Posted

Im going to start working on the small chips and rust spots on my 69,,, so far I have just been sanding them out and priming over the bare metal, but I need to start building the low spots,, so what is the best filler to buy for this,, or should I just leave it and let the body guys do everything.. I figure I dont want to spend any more than $4000 on the paint/body and so far I need a patch pannel for the rear quarter at the wheel lip (usual spot), a new tail light pannel installed,, and just about 12-15 small cracks/chips that are down to metal and primed..

 

The body is really straight with not much wrong with it.. so what filler/ primer can I get for a quality job, done by me... Rattle Can primer?

 

I dont own a compressor, but may get one..

Share this post

Link to post
Share on other sites

Boogerschnot    12

Boogerschnot
Posted

Im going to start working on the small chips and rust spots on my 69,,, so far I have just been sanding them out and priming over the bare metal, but I need to start building the low spots,, so what is the best filler to buy for this,, or should I just leave it and let the body guys do everything.. I figure I dont want to spend any more than $4000 on the paint/body and so far I need a patch pannel for the rear quarter at the wheel lip (usual spot), a new tail light pannel installed,, and just about 12-15 small cracks/chips that are down to metal and primed..

 

The body is really straight with not much wrong with it.. so what filler/ primer can I get for a quality job, done by me... Rattle Can primer?

 

I dont own a compressor, but may get one..

Share this post

Link to post
Share on other sites
Go To Topic Listing
×
×
  • Create New...