v8ford70 98 Report post Posted July 25, 2020 Wanted Kick Panel air vent just require only the cable holding clip & screw.Require 2 of them.Does anyone have a couple of these or know where I might be able to get hold of them.Cheers Phil Quote Share this post Link to post Share on other sites
bobh67 18 Report post Posted July 25, 2020 Hardware stores in the States sell them Quote Share this post Link to post Share on other sites
aslanefe 333 Report post Posted July 25, 2020 Phil, as far as I remember the clip is a piece of bent sheet metal and the screw is sheet metal screw. Similar to the ones used on heater control cables. If you have the ability to make them yourself, I can take pictures with dimensions of the vents on my 70 Cougar. Quote Share this post Link to post Share on other sites
v8ford70 98 Report post Posted July 27, 2020 On 7/26/2020 at 2:17 AM, bobh67 said: Hardware stores in the States sell them What are the parts called? Quote Share this post Link to post Share on other sites
v8ford70 98 Report post Posted July 28, 2020 On 7/26/2020 at 2:26 AM, aslanefe said: Phil, as far as I remember the clip is a piece of bent sheet metal and the screw is sheet metal screw. Similar to the ones used on heater control cables. If you have the ability to make them yourself, I can take pictures with dimensions of the vents on my 70 Cougar. I thought that the hole was for a screw but it may not be ,the clip could have a small tag that goes into the hole & the other end of the clip clips over the top edge of bracket.If you could take a picture of yours & dimensions I may try to make them if I can't pick a couple up.Cheers Phil Quote Share this post Link to post Share on other sites
aslanefe 333 Report post Posted July 28, 2020 1 hour ago, v8ford70 said: I thought that the hole was for a screw but it may not be ,the clip could have a small tag that goes into the hole & the other end of the clip clips over the top edge of bracket.If you could take a picture of yours & dimensions I may try to make them if I can't pick a couple up.Cheers Phil Hi Phil, sorry I was wrong; the clip is not a simple bent piece. See pictures below. But I think you can make a clip like the ones used on heater control cable ends at the heater box or a clip to attach a conduit to wall and secure the cable Quote Share this post Link to post Share on other sites
v8ford70 98 Report post Posted July 28, 2020 8 hours ago, aslanefe said: Hi Phil, sorry I was wrong; the clip is not a simple bent piece. See pictures below. But I think you can make a clip like the ones used on heater control cable ends at the heater box or a clip to attach a conduit to wall and secure the cable No problem,if I can't find some off wrecked vents in US I will have to make something as wont find them here in Australia.Cheers Phil Quote Share this post Link to post Share on other sites
v8ford70 98 Report post Posted January 12, 2022 I'm still trying to get 2 of these clips .Cheers Phil Quote Share this post Link to post Share on other sites
aslanefe 333 Report post Posted January 14, 2022 On 1/12/2022 at 9:29 AM, v8ford70 said: I'm still trying to get 2 of these clips .Cheers Phil Phil, I am not sure if you can find those clips separate, you may have to buy the whole vent to get the clip from. Those clip only hold the shield of the cable in place, you can mount a piece a 2x3 cm sheet metal on top of the cable using a sheet metal screw. Quote Share this post Link to post Share on other sites