TexasEd 188 Report post Posted April 10, 2021 Just took off my door panel on driver side. This is what I saw inside. It looks like there was some sound proofing sprayed in and a piece chipped off and revealed rust. Is this correct. How bad do you think this is? Quote Share this post Link to post Share on other sites
Ridge Runner 1,112 Report post Posted April 10, 2021 It is correct ,all the bubbles is probably where it has lifted and may have rust started under them . Scrap it back and wire wheel the rust away but dont heat up the metal or it will warp ,you could also use a flap wheel on a die grinder . Primer and spray new sound deadner over the area 3 RPM, TexasEd and Mach1 Driver reacted to this Quote Share this post Link to post Share on other sites
Vicfreg 771 Report post Posted April 27, 2021 After carefully scraping off the loose stuff, I put my DynaMat right over that stuff. 2 TexasEd and JayEstes reacted to this Quote Share this post Link to post Share on other sites