lalojamesliz 56 Report post Posted December 18, 2020 Because of the height of the seats ill be installing i won't need the seat pans. Even with my stock pans of my 69 coupe it was too high. With no pans its a perfect height. So the problem i have is i can't install the convertible 1 piece seat pans. I was planning on welding a nice 1/8 sheet of metal (or thicker) where the pan was and maybe some 1/8 sheet pounded/shaped over the tunnel and welded in. I think RPM told me to even consider cutting off the pans and welding in the tunnel part only but this was before I even attempted to remove my pans. Either him or I read that here somewhere. I wanted to do the rockers and pans and leave it like that on the body and work on the front and rear with other methods but since I can't use the pans I'm a little lost. You guys think I'll be good with my idea of welding in some thick sheets of metal and forming some over the the tunnel? I can still cancel the seat pans if I choose. Its not expensive but I don't want that laying around and not be able to use them Quote Share this post Link to post Share on other sites