69Mach1 M code 20 Report post Posted December 8, 2020 I am planning on converting my 69 Mach from the FMX to a 4-speed Toploader. It has a Hurst shifter. Will I need to modify the opening in the console or can I just add a rubber boot? Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted December 8, 2020 I'm doing the same swap, mine sure looks like it'll fit. Quote Share this post Link to post Share on other sites
Kris 90 Report post Posted December 8, 2020 I think you have to change the top shift plate of the console. It just unbolts. 2 Alan_Mac and Grabber70Mach reacted to this Quote Share this post Link to post Share on other sites
aslanefe 333 Report post Posted December 8, 2020 Yes the top plate is different for manual transmission to center the shifter in the plate. But why don't you just try what you have first and see the little offset of shifter is going to stick out. If it does, get a manual top plate for your console. Quote Share this post Link to post Share on other sites
RPM 1,190 Report post Posted December 8, 2020 2 hours ago, aslanefe said: Yes the top plate is different for manual transmission to center the shifter in the plate. But why don't you just try what you have first and see the little offset of shifter is going to stick out. If it does, get a manual top plate for your console. That's good to know. In my situation I pieced the swap parts together and had trouble locating a proper fitting stick. So I cut and spliced a couple of sticks to get the proper offset and centered in the tunnel hole. Quote Share this post Link to post Share on other sites
aslanefe 333 Report post Posted December 8, 2020 This is for manual. this is for auto. You can see the difference for the shifter cutouts in the pictures. All you need is the correct plate for your transmission and I believe you can trim the manual plate to fit auto. Quote Share this post Link to post Share on other sites
69Mach1 M code 20 Report post Posted December 10, 2020 Thanks for the feedback, guys. I am still a few weeks away from starting the tear down but am planning ahead to minimize surprises. Quote Share this post Link to post Share on other sites
Spider69 16 Report post Posted January 3, 2021 Hi, I plan the same swap from fmx, but to a T5. Where could you find the pedals (clutch and brake)? Quote Share this post Link to post Share on other sites
Mike65 475 Report post Posted January 3, 2021 Modern drive line sells the clutch pedal, but you can get it cheaper from CJ's. https://www.cjponyparts.com/modern-driveline-clutch-pedal-assembly-1969-1970/p/CP3/ Here is the power brake pedal with manual trans. https://www.cjponyparts.com/brake-pedal-assembly-manual-transmission-power-brakes-1967-1969/p/PDS/ Quote Share this post Link to post Share on other sites
