Help determining engine location relative to 428

[jpfll 11]

When i installed my engine i used the Ron Morris mounts to move it back and towards the passenger side. Now I’m trying to mock up a ram air setup and would like to know how far the center of my engine/carb is from a stock 69 428CJ

I took the following measurements

Carb stud is approx 13.5” from the cowl - 20” from the inside of the passenger side of the engine compartment and 20.5” from the inside of the driver side of the engine compartment

Would someone with a 428 be willing to take the same measurements so i can compare how my engine/carb sit relative to the 428?

It would be interesting to know the measurements for a 351W too just for comparison sake.

Thanks,

 

[RPM 1,190]

I've got a 428 CJ shaker on my 351W. The scoop just clears the rear opening of the hood with the carb stud at 14-7/8" from the cowl face. Another quarter inch forward would center it. My motor is centered side to side for the shaker to be centered. 

Edit: The reason my side to side numbers are different from yours is I measured side to side from the fender edge, not the inner fender. 

[jpfll 11]

Thanks that helps, i can adjust for the difference between the inner fender and the fender edge

[jmlay 80]

The shaker has some adjustment with the 3 screws that mount the scoop to the midplate.

[RPM 1,190]

1 hour ago, jmlay said:

The shaker has some adjustment with the 3 screws that mount the scoop to the midplate.

Good point bringing that up, and I do have mine as forward as possible. 

[Dave R. 85]

428 shaker; Stud to driver fender edge 23 1/2", stud to pass. fender edge 23 3/8", stud to cowl edge 17 1/4 ".   Dave R.

 

                    

[jpfll 11]

Thank you - that’s helps