JIMWICK 1 Report post Posted August 11, 2020 Can anyone help identify 2 and 3? Quote Share this post Link to post Share on other sites
fvike 173 Report post Posted August 11, 2020 They are fill panels for Fastbacks without fold-down rear seat. 1 SWPruett reacted to this Quote Share this post Link to post Share on other sites
JIMWICK 1 Report post Posted August 11, 2020 46 minutes ago, fvike said: They are fill panels for Fastbacks without fold-down rear seat. I guess I’m asking for a specific name. I searched fill panel and didn’t see anything. Quote Share this post Link to post Share on other sites
jmlay 92 Report post Posted August 12, 2020 . Quote Share this post Link to post Share on other sites
TexasEd 211 Report post Posted August 12, 2020 I think #2 is fixed seat quarter trim. I can't find them on retail but here is one on ebay: https://www.ebay.com/itm/1969-1970-Mustang-Fastback-Mach1-Boss-Shelby-ORIG-LH-FIXED-REAR-SEAT-CORNER-TRIM-/163116464897 3 is a metal channel that goes over the top of the seat. You might get that from a person who did a fold down seat conversion. I think it only goes on fixed seats. Quote Share this post Link to post Share on other sites
JIMWICK 1 Report post Posted August 12, 2020 5 hours ago, TexasEd said: I think #2 is fixed seat quarter trim. I can't find them on retail but here is one on ebay: https://www.ebay.com/itm/1969-1970-Mustang-Fastback-Mach1-Boss-Shelby-ORIG-LH-FIXED-REAR-SEAT-CORNER-TRIM-/163116464897 3 is a metal channel that goes over the top of the seat. You might get that from a person who did a fold down seat conversion. I think it only goes on fixed seats. I saw that on eBay last night haha. So far it doesn't look like they're produced. Thanks! Quote Share this post Link to post Share on other sites
TexasEd 211 Report post Posted August 12, 2020 6 hours ago, JIMWICK said: I saw that on eBay last night haha. So far it doesn't look like they're produced. Thanks! You might need to put out a wanted ad for parts from a Fixed to Fold Down conversion. Alternatively: The top angle piece could be made from aluminum fairly easily but I think it has a texture. Maybe powder coating would work. The side pieces could probably be used to make a mold and then cast them or make them in fiberglass. If you're tech saavy you could maybe get 3D printed since they are not too big. Still need a donor mold to borrow. Quote Share this post Link to post Share on other sites
Hux 45 Report post Posted August 13, 2020 I could have helped but am in Australia.....way too expensive and hard to ship anything long. I am doing the conversion and have all the bits from my conversion. I have a full uncut metal package tray (or whatever you want to call it) as well. Quote Share this post Link to post Share on other sites
