Jump to content
v8ford70

WTB Kick Panel air vent cable clip & screw

Recommended Posts

Wanted Kick Panel air vent just require only the cable holding clip & screw.Require 2 of them.Does anyone have a couple of these or know where I might be able to get hold of them.Cheers Phil

Kick Panel air vent 1.jpg

Kick Panel air vent 2.jpg

Kick Panel air vent 3.jpg

Share this post


Link to post
Share on other sites

Phil, as far as I remember the clip is a piece of bent sheet metal and the screw is sheet metal screw. Similar to the ones used on heater control cables. If you have the ability to make them yourself, I can take pictures with dimensions of the vents on my 70 Cougar.

Share this post


Link to post
Share on other sites

 

On 7/26/2020 at 2:26 AM, aslanefe said:

Phil, as far as I remember the clip is a piece of bent sheet metal and the screw is sheet metal screw. Similar to the ones used on heater control cables. If you have the ability to make them yourself, I can take pictures with dimensions of the vents on my 70 Cougar.

I thought that the hole was for a screw but it may not be ,the clip could have a small tag that goes into the hole & the other end of the clip clips over the top edge of bracket.If you could take a picture of yours & dimensions I may try to make them if I can't pick a couple up.Cheers Phil

Share this post


Link to post
Share on other sites
1 hour ago, v8ford70 said:

 

I thought that the hole was for a screw but it may not be ,the clip could have a small tag that goes into the hole & the other end of the clip clips over the top edge of bracket.If you could take a picture of yours & dimensions I may try to make them if I can't pick a couple up.Cheers Phil

Hi Phil, sorry I was wrong; the clip is not a simple bent piece. See pictures below.

But I think you can make a clip like the ones used on heater control cable ends at the heater box or a clip to attach a conduit to wall and secure the cable

IMG_0747.jpg

IMG_0748.jpg

Share this post


Link to post
Share on other sites
8 hours ago, aslanefe said:

Hi Phil, sorry I was wrong; the clip is not a simple bent piece. See pictures below.

But I think you can make a clip like the ones used on heater control cable ends at the heater box or a clip to attach a conduit to wall and secure the cable

IMG_0747.jpg

IMG_0748.jpg

 No problem,if I can't find some off wrecked vents  in US I will have to make something as wont find them here in Australia.Cheers Phil 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...